Wednesday, May 19, 2010
A happy ending next door to Cabin Down Below
Back on March 25, I did a story on the family who lives next door to the newish entrance to Cabin Down on Seventh Street at Avenue A. The residents were often kept up for hours at night by the clack-clack-clack-clang-clang-clang of footsteps on the steel stairs bargoers use to enter and leave the bar...
As I left off, the resident had heard back from one of the owners, who expressed concern over the situation...
Anyway, good news to report... the resident reports that the problems has been resolved. In recent weeks, a worker has tinkered with the steel stairs. Among other things, the stairs now have rubber treads ... as well as a padded mat at the landing... He said that this has resolved the problem to the point that it no longer disturbs the resident and his family. (Aside from the fix, he said a small part of it had to do with simply getting used to the noise.)
While it did take a few phone calls... a few weeks of waiting, he said that he was happy to report that a resident can still resolve a problem without getting attorneys involved or tossing water balloons at the offending parties.
Perhaps there's hope left for the rest of the neighborhood...?
Previously on EV Grieve:
Life above Cabin Down Below
2 comments:
Your remarks and lively debates are welcome, whether supportive or critical of the views herein. Your articulate, well-informed remarks that are relevant to an article are welcome.
However, commentary that is intended to "flame" or attack, that contains violence, racist comments and potential libel will not be published. Facts are helpful.
If you'd like to make personal attacks and libelous claims against people and businesses, then you may do so on your own social media accounts. Also, comments predicting when a new business will close ("I give it six weeks") will not be approved.
And a little lively discussion on a neighborhood blog never hurts either!
ReplyDeleteWell done, everyone.
yay! so glad for co-existence and cooperation!
ReplyDelete